- Uses the Winkey2 IC
- All external connectors on board for easy assembly
- 4 Message pushbuttons
- Painted and silkscreened enclosure with integrated standoffs
- Independent Outputs to drive two separate rigs
- RCA style Key and PTT outputs on back panel
- Key and PTT outputs are optically isolated
- Sidetone speaker on board
- Front Panel Speed Control
- Paddle connector on back
- USB interface (FTDI Controller based)
- USB driver and documentation provided on CDROM
- USB Cable included
- Internal battery holder for three AAA batteries
- Micro power standby
- Dimensions: 4" W by 3" D by 1.75" H
Copyright 2002-2008 K1EL Systems All Rights Reserved
www.k1el.com
Current WKUSB PCB Revision is D
WKUSB Features
K1EL is offering two kits based on the WK2 chip, WKUSB and WKUSB-HV. Both are identical in function with the exception that WKUSB-HV can key virtually any tube transceiver or transmitter. Both kits includes enclosure, pushbuttons, PC board, and all parts including a USB cable. There is one surface mount part which is pre-soldered to the PCB. All you need to provide are the keying cables from the keyer to your transceiver.
We recently released a new PC board for WKUSB, it is revision D. We have replaced the power jumper with switching diodes which automatically switch from battery power to USB power when attached to a PC. We will begin shipping WKUSBs with WK2 v22 this week.
WKUSB $64 USD
WKUSB-HV $74 USD
WKUSB Kit - $64.00
WKUSB-HV Kit - $74.00
Many folks have asked about a keying cable that can be used between WKUSB and a 1/4 inch transceiver key input jack. Click below to see one that we recommend:
WKUSB Documents
