- Winkey2 Only
- Standalone Settings Only
- Read Current Configuration
- Save Configuration to Disk
- Copy Configuration from Disk to WK2
- Message Editor with Test
- Message Memory Remaining Display
- Total control over all WK2 Standalone Settings
- Speed Pot Status Readout
- Comm Port Selection
- Serial or USB operation
Current WK2MGR Revision is 2.1
WK2MGR Features
WK2MGR is an accessory software application for keyers based upon the Winkey2 IC. This family of WKs can run in standalone mode, not connected to a host PC. Commands and messages can be entered on the paddles but this can be tedious and prone to error. WK2MGR allows you to configure all the settings quickly and easily via an intuitive MS Windows application. Just connect your WK2 keyer to a PC comm port. You can read current settings, modify them, and write them back. In addition you can can save settings to a disk file to maintain a set of configurations that can be loaded depending on operating scenario. Message loading is a breeze, even embedded commands can be included easily and then tested.
For Microsoft Windows
WK2MGR Application
www.hamcrafters.com
Copyright 2002-2013 Hamcrafters All Rights Reserved